| “This site contains affiliate links for which OEMDTC may be compensated” |
T-SB-0019-08
March 19, 2008
ABS Light and/or Cruise Light Flashing and A/C Inoperative
Service Category
Applicability
| YEAR(S) | MODEL(S) | ADDITIONAL INFORMATION |
|---|---|---|
| 2005 – 2007 | Corolla, Matrix | Drive Type(s): 2WD Engine(s): 1ZZ |
Introduction
Some 2005 – 2007 model year Corolla and Matrix vehicles equipped with a 1ZZ-FE engine may exhibit one or more of the following conditions:
- ABS light flashes during vehicle operation
- Cruise light flashes during vehicle operation
- A/C system is inoperative
Use the following procedure to repair the vehicle and address customer concerns.
Warranty Information
| OP CODE | DESCRIPTION | MODEL | TIME | OFP | T1 | T2 |
|---|---|---|---|---|---|---|
| EL8009 | R & R Engine Control Computer (ECM/PCM) | Corolla | 0.4 | 89661-0#### | 01 | 99 |
| EL8010 | Matrix | 0.5 |
APPLICABLE WARRANTY
- This repair is covered under the Toyota
Federal Emission Warranty. This warranty is in effect for 96 months or 80,000 miles, whichever occurs first, from the vehicle’s in-service date. - Warranty application is limited to correction of a problem based upon a customer’s specific complaint.
Parts Information
| MODEL | TRANS | PREVIOUS PART NUMBER | CURRENT PART NUMBER | PART NAME | QTY | ||
|---|---|---|---|---|---|---|---|
| 2005 MY | 2006 MY | 2007 MY | |||||
| Corolla | A/T w/VSC | 89661-02C0# | 89661-02C9# | 89661-02K10 | 89661-02K11 | Engine
Control Module | 1 |
| A/T w/o
VSC | 89661-02C1# | 89661-02D0# | 89661-02K20 | 89661-02K21 | 1 | ||
| Matrix | A/T w/VSC | 89661-0112# | 89661-02D4# | 89661-02K30 | 89661-02K31 | 1 | |
| A/T w/o
VSC | 89661-0113# | 89661-02D5# | 89661-02K40 | 89661-02K41 | 1 | ||
| Corolla
& Matrix | M/T | 89661-0Z04# | 89661-02D1# | 89661-02K50 | 89661-02K51 | 1 | |
Required Tools & Equipment
| REQUIRED EQUIPMENT | SUPPLIER | PART NUMBER | QTY |
|---|---|---|---|
| TIS techstream*
NOTE: Software version 2.20.015 or later is required. | ADE | TSPKG1 | 1 |
* Essential SST.
NOTE
- Additional TIS techstream units may be ordered by calling Approved Dealer Equipment (ADE) at 1-800-368-6787.
- The Toyota Diagnostic Tester and CAN Interface Module may also be used to perform the service procedures listed in this bulletin.
Repair Procedure
- Confirm that the condition matches the criteria in the Introduction of this TSB and that NO other faults are present in the related systems.
- Replace the ECM (PCM).
Refer to the Technical Information System (TIS):
- 2005 model year Corolla Repair Manual, Engine/Hybrid System – Engine Control – “ECM (1ZZ-FE/2ZZ-GE): Replacement”
- 2006 or 2007 model year Corolla Repair Manual, Engine/Hybrid System – Engine Control – “1ZZ-FE Engine Control System: ECM Removal”
- 2006 or 2007 model year Corolla Repair Manual, Engine/Hybrid System – Engine Control – “1ZZ-FE Engine Control System: ECM Installation”
- 2005 model year Matrix Repair Manual, Engine/Hybrid System – Engine Control – “ECM (1ZZ-FE/2ZZ-GE): Replacement”
- 2006 or 2007 model year Matrix Repair Manual, Engine/Hybrid System – Engine Control – “1ZZ-FE Engine Control System: ECM Removal”
- 2006 or 2007 model year Matrix Repair Manual, Engine/Hybrid System – Engine Control – “1ZZ-FE Engine Control System: ECM Installation”
Refer to TIS:
- 2005 model year Corolla Repair Manual, Engine/Hybrid System – Engine Control – “SFI System (1ZZ–FE): Registration”
- 2006 or 2007 model year Corolla Repair Manual, Engine/Hybrid System – Engine Control – “1ZZ–FE Engine Control System: SFI System: Registration”.
- 2005 model year Matrix Repair Manual, Engine/Hybrid System – Engine Control – “SFI System (1ZZ–FE(FF)): Registration”
- 2006 model year Matrix Repair Manual, Engine/Hybrid System – Engine Control – “1ZZ–FE Engine Control System: SFI System (for 2WD): Registration”.
- 2007 model year Matrix Repair Manual, Engine/Hybrid System – Engine Control – “1ZZ–FE Engine Control System: SFI System: Registration”.
- Confirm the repair.
Loading...
Reload document 
Open in new tab
Approved J2534 Devices only provide reprogramming capabilities and do not support diagnostic scantool functions. For full diagnostic capabilities, please consider TIS Techstream or Techstream Lite
Toyota, Scion, and Lexus ECMs can be reprogrammed with the TIS Techstream, Techstream Lite, Diagnostic Tester, or can also be reprogrammed using a Toyota validated J2534 interface. Vehicle recalibration requires the use of the following:
- Toyota validated J2534 interface
- TIS Professional Level Subscription
- Toyota Calibration Update Wizard software (installed along with Techstream Software)
- Personal Computer running Microsoft Windows XP/2000 or later operating system
Toyota strongly recommends USING ONLY VALIDATED INTERFACE DEVICES that appear on this list.
Toyota works closely with J2534 interface manufacturers to ensure that their hardware works safely and efficiently with our products. Every device listed on this page has been thoroughly tested and validated on Toyota, Scion, and Lexus vehicles.
It is important to understand that only the specific devices, firmware, DLLs and APIs listed here have been tested by Toyota. We do not recommend use of any other J2534 device, firmware, DLL or API that is not listed here. Changes to J2534 hardware/software is outside of Toyota’s control; in some cases, changes made to device hardware/software can negatively impact reprogramming performance. Toyota makes every effort to continue to work with J2534 interface manufacturers to ensure continued product compatibility as our respective products evolve.
J2534 Approved Device Application Chart
| Supplier | Device Name | Version | CUW Version | Supported OS | ||
|---|---|---|---|---|---|---|
| Firmware* | DLL* | API* | ||||
| Bosch Diagnostics | Flasher LT-Import | 01.02.07 | 01.02.07 | 04.04 | 8.8 | B, C, D, E |
| Bosch Diagnostics | Flasher PRO | 01.09.18 | 01.09.18 | 04.04 | 8.8 | B, C, D, E |
| Bosch Diagnostics | Mastertech VCI | 13.0.75.27 | 2.0.75.27 | 04.04 | Testing in Progress | B, C, D, E |
| Dearborn Group | VSI-2534  | 1.112 | 2.05.22 | 04.04 | 8.10 | C, D |
| Drew Technologies | CarDAQ Plus | 01.09.18 | 01.09.18 | 04.04 | 8.8 | B, C, D, E |
| Drew Technologies | Mongoose MFC | 01.02.07 | 01.02.07 | 04.04 | 8.8 | B, C, D, E |
| Drew Technologies | Mongoose PRO | 1.1.12.0 | 1.1.12.0 | 04.04 | 8.16 | A, B, C, D |
| Snap-On | Pass Thru Pro II | 01.09.18 | 01.09.18 | 04.04 | 8.8 | B, C, D, E |
*Original validated firmware/DLL versions may be superceded by the device manufacturer. Contact the device manufacturer if you are unable to find the versions listed above.
Supported Operating Systems
| A | Windows 8 (32-bit; 64-bit) |
| B | Windows 7 (32-bit; 64-bit) |
| C | Windows VISTA Home Basic, Home Premium, Business, Ultimate |
| D | Windows XP Pro SP1 or later |
| E | Windows 2000 SP2 or later |
For more information about the J2534 devices listed above, click on the vendor names. To report compatibility problems with listed hardware/software, please contact the device manufacturer.
Obtaining Calibration Files
The Flash Reprogramming Calibration CD is no longer available.
ECU Calibrations are now available for download directly from TIS. A valid TIS Professional Level subscription is required to access Calibration files. These files are compatible with the above mentioned scantools and J2534 interfaces. The Calibration page, located on the Diagnostics tab in the TIS site, contains all the most current vehicle calibration files, applicable Service Bulletins, and instructions for use. Select the following link for step by step instructions to access this page.
Note: Calibration Update Software is now included in the Techstream Software Installer. A valid TIS Professional Level subscription is required to download and install Techstream Software.
